To integrate all of these options into our vehicle we have to use a wide range of parts to correctly complete the installation. When we build your custom package we will go over the parts required to complete your package. Here is a short list of some of the products we use.

 

Amplifier Installation Kits:
These are all the power wires to install your new amplifier. These vary from a basic 8 or 10 Gauge kit to the high current 0 Gauge wires.

 

Capacitors and Power Cells:
These are batteries for your amplifier to use. When your amplifier is working hard it needs a lot of current. Most vehicles today just can’t produce the kind of voltage that some amplifiers require. It can put a lot of stress on your vehicle ‘s electrical system trying to run an amplifier without the proper parts. A capacitor or power cell will provide a reserve of current for the amplifier to operate properly. Capacitors will work for smaller systems where the demand for current is not as large. Power cell’s will often provide 100 times as much reserve power for your system. When bigger is better the current demand will be high, these guys will protect your investment.

 

Pre-Amplifiers/Equalizers: These are used to either integrate an amplifier to a factory radio, or to make an aftermarket radio sound even better. They are used so send a 'hotter' signal to the amplifier and give an even better signal-to-noise ratio as well as reject induced noise from other electronics in the vehicle. Equalizers are used to remove the unnatural response curve of a factory radio, or to fine tune your system for the most realistic sound possible. We use Audiocontrol products and real-time-analizers exclusively for the highest level of sound quality. A major side benefit is that they are hand-built right here in the Pacific Northwest by audiophiles, for audiophiles. Period.

 

RCA Cables:
These cables carry the low level sound from the preamp to the ampilifer. These vary from basic to Competition Grade.

 

Dash Fit Kits:
These kits allow us to install your new radio in the dash of your vehicle without modifying the dash. When you sell or trade the vehicle we can return it to stock, so you can keep our new equipment. If there isn’t a dash fit kit made for your application then we may be able to custom build one for you.

 

Wire Harness Adapters:
The Harness allows us to connect to your vehicle’s electrical system without modifying or cutting the vehicle’s radio harness. When you sell or trade the vehicle we can return it to stock, so you can keep our new equipment.

 

Factory Can Bus Integration:
More and more vehicles today are running the vehicle computer system through the factory radio. In order for us to integrate your new radio we have to use a Can Bus adapter. These retain all the factory computer functions and features.

 

Misc wire, wire fittings, and shop supplies:
Every installation requires all kinds of miscellaneous parts. We order high quality wire and parts so that your install will be trouble free for a long time. We provide a life time labor warranty on all of our installation. We do not want to waste your or our time to replace low quality parts that shouldn’t have been there in the first place.